When selected, layer content can be easily moved, resized and sheared by adjusting the values in the Transform panel.
About the Transform panel
The Transform panel repositions, sizes, rotates, or shears layer content precisely. All transforms are carried out in relation to a defined anchor point—corner, edge midpoint or centre—allowing the selected transform to be adjusted.
If an object has a custom rotation centre applied, it can be resized, rotated or sheared about that centre using the options on the panel.
The following controls are found on the Transform panel:
Anchor point selector—transforms are carried out from the selected anchor point. Click on an anchor point to select. If the layer content has a custom rotation centre, it will be ignored if this selector is then used.
X—Horizontal position. Increasing the value moves the layer content to the right.
Y—Vertical position. Increasing the value moves the layer content down the page.
W—Width. Adjusts the layer content's width in relation to the selected anchor point.
H—Height. Adjusts the layer content's height in relation to the selected anchor point.
Link—When enabled, width and height are adjusted in proportion to each other, maintaining the current aspect ratio. When deselected, they can be adjusted independently.
R—Rotation. Rotates the layer content by a specified number of degrees in relation to the selected anchor point.
S—Shear. Shears the layer content by a specified number of degrees in relation to the selected anchor point.
L—Length. Replaces Shear (S) when a straight line is selected using the Move Tool. Allows you to precisely adjust the line's length. The Anchor point selector changes its appearance for straight lines.