Double Star Tool

Settings

The following settings can be adjusted using a vertical tool slider:

• Width—controls the width of the line using a vertical slider next to the tool's location. Slide up or down to set the width.

The following settings can be adjusted from the context toolbar:

• Keep selected—when enabled (default), the new shape layer will be selected on creation. When disabled, the new object is deselected which prevents it from adopting the next object’s stroke/fill properties.
• Points—sets the number of protrusions on the shape.
• Inner radius—controls the length of the points relative to the centre of the star.
• Point radius—controls the length of the secondary points relative to the centre of the star.
• Convert To Curves—converts the selected object into a series of connected lines and nodes.