Layer blend ranges

Blending ranges let you blend layers in a project tonally. This is done by controlling the opacity across the tonal range of the currently selected layer and/or the composite layer(s) beneath that layer.

About blend ranges

Blend ranges allow you to specify how tonal values of a layer blend with the layer(s) below. You can set the range of the tonal values affected and can set the range to have any level of opacity (from opaque to transparent).

Before
After
Before and after blend range applied.

The blend range of the selected layer and the underlying layer(s) is controlled via the spline graphs in Layer Options, accessed by tapping Layer Options.

You can change the blend range for individual colour channels by changing the setting above the spline graphs.

About blend gamma and antialiasing (RGB documents only)

Layer Options allow you to adjust the blend Gamma of the selected layer. This gives you the option of designing using a linear-RGB colour space (1.0), regular sRGB-blending (2.2) or any gamma value up to 3.0. In other words, it gives you full control over how the tones of semi-transparent or antialiased edged objects interact with colours underneath.

Linear-RGB
Regular sRGB-blending
Blue rectangle using regular sRGB-blending (2.2 gamma; before) and linear-RGB (1.0 gamma; after).

Antialiasing is the reduction of the jagged appearance of lines on a pixel grid. Antialiasing is achieved by the addition of semi-transparent pixels along the line to smooth the transition from the line's edge to background objects. This area of transition is sometimes referred to as the antialiasing ramp or antialiasing coverage.

Layer Options allow you to adjust the antialiasing ramp (coverage) of the selected layer, as well as control how (and if) antialiasing is inherited or set independently of other layers. For improved workflow, child layers nested hierarchically in a parent layer can inherent the parent layer's antialiasing setting automatically but can be forced to apply antialiasing or ignore it.

Settings

The following settings are available via Layer Options:

The following settings can be adjusted for both the Source and the Dest graphs:

Layers panel Layer Options To change blend ranges:
  1. On the Layers panel, select a layer.
  2. Tap Layer Options.
  3. Adjust the blend range settings at the bottom of the dialog.
  4. Tap Source and Dest to reveal their spline graphs. Modify as required.
To adjust a graph directly:

Do any of the following:

SEE ALSO: