Viewing

There are a variety of viewing choices available which let you preview your designs before output using view modes or make mode comparisons.

About view modes

Vector

Pixels

Retina Pixels

Outline

X-ray

Hairline

Vector view mode

Drawn objects are displayed as vectors by default. This means that, regardless of the current zoom level, objects (and applied effects) are always presented with smooth vector edges and transitions.

Pixels view mode

During design, vector objects are presented as if they are constructed from individual pixels. This is an accurate representation of how your design will appear once exported and viewed as an image.

Retina Pixels view mode

As for Pixel mode above, but represents how your design will display on retina and high DPI displays.

Outline view mode

During design, page objects are presented as paths only (with no fills or strokes). All otherwise obscured paths are exposed, and selection behaviour changes so grouped objects can immediately be selected just like ungrouped ones. In complex designs, this can be used to more easily target unlocked and locked objects for selection.

X-ray view mode

As for Outline view mode, but page objects still display their fills at reduced opacity. On more complex designs, perhaps when zoomed in, this helps to interpret the view better.

Hairline view mode

For CAD documents, Hairline mode displays designs as CAD apps would display them. All lines are displayed as thin lines so line weights are ignored, regardless of zoom level.

Views

Views
Single and split views. The latter showing a 'Vector - X-ray' view mode comparison.

Main View

Presents the selected mode in isolation on a single page.

Split View

Simultaneously presents two modes side-by-side on the same page, allowing for a visual comparison to be made. A sliding divider can be repositioned to view different areas of the design in either mode.

View mode options

These are not modes but additional options that can be applied to any view mode.

Greyscale

This gives the option of viewing your document in greyscale. This is useful when evaluating contrast and dynamic range more easily.

Hide Effects

This hides any layer effects applied to your document. It helps to improves performance on more complex documents where extensive layer effects are used.

You can apply different option settings to different sides of a split view.

View mode options
Greyscale and Hide Effects view mode options when enabled.
To toggle between view modes:
To compare view modes simultaneously using split view:
Greyscale view mode option No FX view mode option To enable or disable view mode options:

SEE ALSO: