Polygon Tool

Settings

The following settings can be adjusted using a vertical tool slider:

• Width—controls the width of the line using a vertical slider next to the tool's location. Slide up or down to set the width.

The following settings can be adjusted from the context toolbar:

• Keep selected—when enabled (default), the new shape layer will be selected on creation. When disabled, the new object is deselected which prevents it from adopting the next object’s stroke/fill properties.
• Sides—sets the number of sides (and angles) of the polygon.
• Curve—sets the convex or concave nature of the sides of the polygon. The percentage curve available is determined by the number of sides. For straight sides, set to 0%.
• Smooth points—applies smoothing to the points of the polygon, resulting in the appearance of a continuous curve. This only applies when the curve of sides is greater than 0%.
• Convert to Curves—converts the selected object into a series of connected lines and nodes.