Callout Rectangle Tool

Settings

The following settings can be adjusted using a vertical tool slider:

• Width—controls the width of the line using a vertical slider next to the tool's location. Slide up or down to set the width.

The following settings can be adjusted from the context toolbar:

• Keep selected—when enabled (default), the new shape layer will be selected on creation. When disabled, the new object is deselected which prevents it from adopting the next object’s stroke/fill properties.
• Radius—sets the radius of the rectangle's rounded corners.
• Tail End—controls the position of the point of the protrusion from left (0%) to right (100%), with 50% representing a central point.
• Tail Start—controls the position of the protrusion along the base of the shape from left (0%) to right (100%), with 50% representing a central point.
• Convert to Curves—converts the selected object into a series of connected lines and nodes.