Pixels added to a selection are determined by the color of pixels under the tool when you tap on the page. You can control the selection tolerance, i.e. how much the selection will grow to encompass pixels of similar color values under the cursor.
Settings
The following settings can be adjusted from the context toolbar:
- Mode—select from New, Add, Subtract, and Intersect.
- Source—the source determines the layer(s) from which the pixels are sampled from. Select from the pop-up menu.
- Tolerance—sets the range of pixels affected when a pixel is tapped. For lower tolerance settings, pixels must be very close in value to the tapped pixel. For higher tolerance settings, pixel color can vary widely from the tapped pixel.
- Contiguous—when enabled, only selects a range of pixels within the same area. If disabled, similar pixel ranges will be selected even if they are separated and in different parts of the image.
About selection modes
The four modes available from the context toolbar affect how your selection develops.
- New—cancels all current selections and creates a new selection.
- Add—adds areas to the current selection. If there is no selection in place, a new selection will be created.
- Subtract—removes areas from the current selection.
- Intersect—a new selection area is created from the overlap between the newly added selection area and the current selection.
Flood Selection Tool