Flooding pixel selections

Using the Flood Selection Tool you can define a selection of similar colour value pixels with a single tap.

Flooding and tolerance

When using the Flood Selection Tool, Affinity Designer will analyse the target (tapped) pixel and use its colour value to create a selection which includes pixels with similar colour values.

Before
After
Before and after pixel selection.

The number of pixels selected is determined by the tool's tolerance setting. The higher the tolerance the more variance allowed between the target pixel and selected pixels. Therefore a higher tolerance will likely lead to more pixels being included in the selection.

This makes selecting an area of similar colour and tone effortless.

Contiguous behaviour

By default, flood selecting is contiguous. This means pixels with similar colour values must be adjacent to one another to be selected. Therefore, pixels must be directly connected to the target pixel (or other selected pixels) to be selected. If there is a high contrast edge between areas of similar colour, the pixels on the opposite side of the edge will not be selected using a single tap.

As an alternative, the contiguous behaviour can be switched off. This will mean pixels of similar colour to the target pixel will be selected regardless of their position within the image.

Contiguous
Non-contiguous
Difference in selection method with contiguous on (before) and off (after).
Pixel Persona Flood Selection Tool To create a pixel selection:
  1. From the Pixel Persona, select the Flood Selection Tool.
  2. (Optional) On the context toolbar, set the Tolerance.
  3. Tap on your page.
Flood Selection Tool To create a pixel selection using multiple target pixels:

With the Flood Selection Tool selected:

  1. On the context toolbar, set the Mode to Add.
  2. Tap on your page.
  3. Repeat step 2 as needed.
Flood Selection Tool To switch off contiguous selection:

SEE ALSO: