Segment Tool

Settings

The following settings can be adjusted using a vertical tool slider:

• Width—controls the width of the line using a vertical slider next to the tool's location. Slide up or down to set the width.

The following settings can be adjusted from the context toolbar:

• Keep selected—when enabled (default), the new shape layer will be selected on creation. When disabled, the new object is deselected which prevents it from adopting the next object’s stroke/fill properties.
• Angle—sets the shape's starting angle.
• Lower Line/Upper Line—controls the position of the shape's two straight lines. This determines the thickness of the segment.
• Mirror—updates the above settings to give a reversed (flipped) version of the current shape.

  

• Negate—updates the above settings to give the inverse (opposite) of the current shape.

  

• Convert To Curves—converts the selected object into a series of connected lines and nodes.