Affinity Designer supports an impressive selection of different blend modes. The most commonly used blend modes are as follows:
Normal—The default blend mode. The top pixels display over underlying pixels according to the level of top layer opacity.
Multiply—The blending result is a combination of the top and bottom colour at each pixel position, always producing a darker value.
Screen—The opposite of Multiply, where the blending result is a combination of the inverse of the top and bottom colour at each pixel position, always producing a lighter value.
Overlay—Applies either Multiply or Screen blend mode, depending on the bottom colour at each pixel position. If the bottom layer pixels are <50% grey, it multiplies; if >50% it screens.
Divide1—Lower layers are lightened by luminance on the upper layer. White has no effect. Lightness is increased progressively by grey through to black.
Colour Burn1—Darkens the bottom colour pixels relative to the values of the top colour pixels.
Other available blend modes include Darken, Darker Colour, Linear Burn, Lighten, Lighter Colour, Colour Dodge1, Add, Soft Light, Hard Light, Vivid Light, Pin Light, Linear Light, Hard Mix, Difference1, Exclusion1, Subtract, Hue2, Saturation2, Luminosity, Colour2, Average1, Negation1, Reflect1, Glow1, Contrast Negate, Erase and Passthrough.
1 Not available in Lab16 mode.
2 Not available in Greyscale mode.
To change the blend mode of a layer (or object):
In the Layers panel, select a layer (or object).
Choose a blend mode from the pop-up menu on the panel.
